Owner's Manual

Using Dell Lifecycle Controller Integration 25
3
Using Dell Lifecycle Controller
Integration
This section provides information on the various operations that you can
perform after you install Dell Lifecycle Controller Integration (DLCI) on
Microsoft System Center Configuration Manager (Configuration Manager).
Before you begin using DLCI for Configuration Manager,
ensure that the
target system is auto-discovered and present in the
All Dell Lifecycle
Controller Servers collection on the Configuration Manager console.
DLCI for Configuration Manager enables you to perform the following
operations on all Dell systems under the All Dell Lifecycle Controller Servers
collection:
• Configure Connections License Manager with DLCI, see Licensing For
DLCI Using Dell Connections License Manager and Configuring Dell
Lifecycle Controller Integration With Connections License Manager.
• Configure the target systems. For more information, see Configuring
Targ et S y s te ms .
• Apply drivers on the task sequence. For more information, see Applying
Drivers On The Task Sequence.
NOTE: Select the checkbox Apply Drivers from Lifecycle Controller
if you want to apply drivers from Lifecycle Controller while deploying the
operating systems.
• Create a task sequence media. For more information, see Creating A Task
Sequence Media (Bootable ISO).
•Use the
System Viewer utility on specific systems in a collection.
For more information, see System Viewer Utility.
•Use the
Config Utility on a collection of Dell systems.
For more information, see Config Utility.
DLCI_UserGuide.book Page 25 Friday, October 12, 2012 7:16 PM