Owner's Manual

102 Using The System Viewer Utility
3 Select the options for the properties as given in the table below:
4 Click Finish after selecting the required options.
The following message is displayed:
Task submission complete.
Table 6-2. Part Replacement Attributes
Property Options
Collect System Inventory on
Start (CSIOR)
• Disabled — Disables CSIOR for the replaced
part.
•
Enable — Enables CSIOR for the replaced part.
•
Do Not Change — Retains the default settings
as is. This is selected by default.
Part firmware update • Disabled — Select this option if you do not
want firmware updates to the replaced part.
•
Allow version upgrade only — Select this
option to perform firmware update on replaced
parts if the firmware version of the new part is
lower than the original part.
•
Match firmware of replaced part — Select this
option to perform firmware update on replaced
parts to the version of the original part.
•
Do Not Change — Select this option to leave
the default settings as is. This is selected by
default.
Part configuration update • Disabled — Select this option if you do not
want to apply the current configuration to a
replaced part.
•
Apply always — Select this option to apply the
current configuration to the replaced part.
•
Apply only if firmware matches — Select this
option to apply the current configuration only if
the current firmware matches with the firmware
of the replaced part.
•
Do Not Change — Select this option to leave
the default settings as is. This is selected by
default.
DLCI_UserGuide.book Page 102 Friday, October 12, 2012 7:16 PM