Owner's Manual

10 Introduction
A single installer to install
and configure Dell
Lifecycle Controller
Integration
You can use the single installer to install DLCI 2.0.1 in
environments (Configuration Manager 2007 or
Configuration Manager 2012) based on the version of
Configuration Manager present in the system. If a
previous version of DLCI is present with Configuration
Manager 2007, then the installer will initiate an upgrade.
The installer will deploy appropriate components based
on the Configuration Manager version and its
components installed in the server.
Automatically configure
Dell Provisioning Server
During installation you can choose to automatically
configure Dell Provisioning Server.
All features of Dell
Lifecycle Controller
Integration 2.0.1 are
supported for
Configuration Manager
2012
After you install DLCI in the Configuration Manager
2012 environment, all the DLCI features are enabled.
Network interface cards
(NIC) / converged network
adapter (CNA) cards
New NIC/CNA card configurations are supported.
Storage controllers with
12G servers
New storage controllers are supported.
Licensing for Dell
Lifecycle Controller
Integration
Enables licensing for DLCI. Licensing is based on the
number of nodes.
Operating System
Deployment
You can deploy non-Windows operating systems, Red
Hat Enterprise Linux Version 6.2, VMware ESXi 5 HDD,
and VMware ESXi 5 U1 HDD from Configuration
Manager.
Table 1-1. New Features and Functionalities
(continued)
New Feature Functionality
DLCI_UserGuide.book Page 10 Friday, October 12, 2012 7:16 PM