Owner's Manual
Table Of Contents
- Dell Lifecycle Controller Integration For Microsoft System Center Configuration Manager Version 2.0.1 Installation Guide
- Introduction
- Prerequisites
- Configuring An Account For Use With Discovery And Handshake
- Configuring User Access To WMI
- Providing User Permissions For DCOM
- Providing User Permissions For DCOM Config WMI
- Setting Namespace Security And Granting Permissions
- Validating User Permissions From The Dell Provisioning Server
- Providing Share And Folder Permissions
- Enabling Remote PowerShell Commands For Dell Provisioning Server
- Software Prerequisites And Requirements
- Configuring An Account For Use With Discovery And Handshake
- Installing DLCI For Configuration Manager
- Troubleshooting
Operating Systems Dell Provisioning Service
Windows XP SP2 x86 Business Edition
Windows XP SP3 x86 Business Edition
Windows Vista x86 Business Edition
Windows Vista SP1 x86 Business Edition
Windows 7 x86 Edition
Windows Server 2008 SP2 — Standard and Enterprise x86
Editions
The following operating systems are supported for Configuration Manager 2007/2012.
Windows Server 2008 — Standard, Enterprise, and
Datacenter x64 Editions
Windows Server 2008 SP2 — Standard, Enterprise, and
Datacenter x64 Editions
Windows Server 2008 R2 — Standard, Enterprise, and
Datacenter Editions
Windows XP SP2 x64 Professional Edition
Windows XP SP3 x64 Professional Edition
Windows XP SP2 x64 Business Edition
Windows XP SP3 x64 Business Edition
Windows Vista x64 Business Edition
Windows Vista SP1 x64 Business Edition
Windows 7 x64 Edition
Enabling Or Disabling WMI Traffic Using Firewall
If firewall is enabled on Dell Lifecycle Controller Utility for Configuration Manager 2012, then, to run remote PowerShell
commands for the WMI class, you must enable the WMI traffic.
To enable WMI traffic using firewall user interface:
1. In Control Panel, click Security and then click Windows Firewall.
2. Click Change Settings, and then click Exceptions.
13