Users Guide

PowerShell Group Policy: technet.microsoft.com/library/jj149004
2. Once the execution policy is set, restart the Integration Gateway server.
Hypervisor deployment fails for 11th generation
PowerEdge blade servers when using Active Directory
Hypervisor deployment fails on the 11th generation PowerEdge blade servers when using the Active
Directory user credentials. The 11th generation PowerEdge blade servers use the Intelligent Platform
Management Interface (IPMI) protocol for communication. However, the IPMI standard is not supported
for using credentials from the Active Directory setup.
As a workaround to deploy operating systems on these servers, use supported credential profiles.
RAID configuration failure for virtual disks with RAID10
RAID configuration fails when virtual disks are created with RAID level 10 for controller H200 using more
than four physical disks.
RAID 10 with more than four physical disks will fail.
As a workaround, use minimum number of physical disks required for that RAID level.
Firmware update on few components irrespective of the
selection
Same components on identical servers get updated during a firmware update irrespective of the selection
of components made on individual servers. This behavior is seen for 12th and 13th generation of Dell
PowerEdge servers with Enterprise license of iDRAC.
As a workaround, do one of the following:
In order to prevent irrelevant updates on identical servers, apply common components on identical
servers and then apply specific components separately on individual servers.
Perform staged updates with planned outage times to accommodate the required firmware update.
Configuration of RAID failure due to configuration of hot
spares on software RAID S130
RAID configuration on software RAID controller S130 fails when we try to configure RAID with more than
three hot spares including the global hot spare (GHS) and DHS.
As a workaround:
Use only three hot spares (GHS and DHS) to apply on a profile.
Use PowerEdge RAID controller (PERC) card.
45