Setup Guide

To upgrade Integration Gateway to version 1.1:
Prerequisites: Make sure the shared folder created has a minimum disk space of 10 GB.
NOTE: The installation continues with a warning message even if there is no disk space of 10 GB
space. However operating system deployment, and firmware update may fail.
1. From the Admin portal, download the Integration Gateway installer.
2. Run the DLCI Integration Gateway for SC2012 VMM installer.
3. In the message prompting you to upgrade, click Yes.
4. In the DLCI Integration Gateway for SC2012 VMM Welcome page, click Next.
5. In License Agreement, select I accept the terms in the license agreement, and then click Next.
6. In License: Open-Source Software, refer the open-source related information and click Next.
7. In Integration Gateway Configuration, provide details of Integration Gateway service account user
and port number. To change the staging server location, click Select Share Folder and traverse to
the new location and then click Next.
Assign a port for communication between appliance and Integration Gateway. The default port that
is enabled is 8455. However, you can configure a different port number based on the requirement.
Execution policy for Integration Gateway service user account is set to Unrestricted.
8. In Destination Folder, default installation folder is selected, to change location click Change and
traverse to the new location. Once you complete the changes, click Next.
9. In Ready to Install the Program, click Install.
10. Once the installation is complete, click Finish.
Post-requisites: After upgrading to this version of DLCI for SC2012 VMM, rediscover the servers used in
earlier versions to use the new features.
15