Setup Guide

g. In Integration Gateway Configuration, provide details of Integration Gateway service account
user and port number. To change the staging server location, click Select Share Folder and
traverse to the new location and then click Next.
NOTE: Make sure the shared folder created has a minimum disk space of 10 GB.
Assign a port for communication between appliance and Integration Gateway. The default port
that is enabled is 8455. However, you can configure a different port number based on the
requirement.
Execution policy for Integration Gateway service user account is set to Unrestricted.
h. The default installation folder Integration Gateway for VMM is selected, to change location click
Change and traverse to the new location. Once you complete the changes, click Next.
i. In Ready to Install the Program, click Install.
The following shared directories are created during installation of Integration Gateway:
• DTK
• LCDriver
• ISO
• OMSA
• WIM
j. Once the installation is complete, click Finish.
16. In Setup and Configuration, in Server Details, provide the following information and then click Next:
a. Fully Qualified Domain Name (FQDN) of the SC2012 VMM Server and SC2012 VMM Server
Administrator User Credentials.
SC2012 VMM Server Administrator user should not be a SC2012 VMM service account.
b. Fully Qualified Domain Name (FQDN) of the server where the Integration Gateway is installed and
Integration Gateway Service Account User Details and appropriate port number of the Integration
Gateway (where 8455 is default port number)
17. Click Apply, to complete the registration process.
18. In Optional Setting and Installation, In Console Add-in Installation, click Download Installer and
save the installer file to the required location.
19. To install Console Add-in, see Working With DLCI Console Add-in for SC2012 VMM in the Dell
Lifecycle Controller Integration for Microsoft System Center 2012 Virtual Machine Manager User’s
Guide.
Modifying Integration Gateway
Using this option you can only change the password. You cannot edit the user name or port information.
Prerequisites for modifying credentials for the SC2012 VMM administrator user are that the user has
already modified the password in the active directory.
To modify the Integration Gateway:
1. Run the DLCI Integration Gateway for SC2012 VMM installer.
2. In Program Maintenance, select Modify and then click Next.
3. Change password and then click Next.
4. In Modify the program, click Install.
5. When the modify task is complete click Finish.
11