Owner's Manual

Using the System Viewer Utility 81
Configuring NIC and iSCSI Parameters
You can configure the NIC and iSCSI parameters from the Port Settings
screen.
To configure the NIC and iSCSI parameters:
1 In the Port Settings screen, on the NIC tab, specify the following
parameters:
– Select All — Select this to check all the options available for NIC.
– Boot protocol — Select the protocol for booting the system. You can
choose from
PXE , iSCSI , or FCoE .
– Wake on LAN — This option allows you to switch on the system
throughout your LAN. You can choose to enable or disable this option.
– Wake on LAN link speed — Specify the Wake on LAN link speed
from the drop-down list.
– VLAN mode — This option allows you to add your system to a VLAN
if it is not located on the same network switch. You can choose to
enable or disable this option.
– Link speed — Specify the NIC link speed by selecting from the drop-
down list.
– Flow Control — Specify the data flow control by selecting from the
drop-down list.
– IP auto configuration — This option allows you to automatically
configure the IP address for the system. You can choose to enable or
disable this option.
– SRIOV configuration — This option allows you to configure Single
Root Input/Output Virtualization for the system. You can choose to
enable or disable this option.
Click OK to save the settings.
2 Click the iSCSI tab and specify the following parameters:
– CHAP authentication — Enable or disable the challenge handshake
authentication protocol (CHAP) for the system while discovering an
iSCSI target. If you enable this option, you must enter the CHAP ID
and CHAP Secret throughout the iSCSI Initiator Parameters
Configuration screen.
DLCI_UserGuide.book Page 81 Tuesday, November 22, 2011 5:00 PM