Owner's Manual

80 Using the System Viewer Utility
Configuring Adapters
To configure the adapters:
1 Select the adapter on the Network Adapter Configuration screen and click
Configure. The
Adapter Configuration dialog box is displayed.
2 Select one of the following options:
– Configure adapter settings — to configure the settings.
– Copy settings from adapter — to copy the configuration settings from
an adapter that is already configured.
3 Click Configure, the Configure Adapter dialog box is displayed. Select the
port that you want to configure and click
Configure .
4 Select one of the following options:
– Configure port settings — to configure the port settings. Proceed to
the next step if you want to configure the port settings yourself.
– Copy settings from port — to copy the port settings from a port that
is already configured. Proceed to
step 7 if you are copying the port
settings.
5 You need to choose the personalities for each partition on the port, enter
bandwidth and configure settings for each personality. One port can have
up to four partitions with one personality assigned to each partition.
Under Personalities and Settings , select the personality against each
partition and set the minimum and maximum bandwidth. You can select
from one of the following options:
–NIC
–iSCSI
–FCoE
NOTE: You can select the personalities only for CNAs and not for NICs.
6 Click Port Settings to configure the NIC and iSCSI parameters. For more
information, see
Configuring NIC and iSCSI Parameters.
7 Click OK to save the configurations.
DLCI_UserGuide.book Page 80 Tuesday, November 22, 2011 5:00 PM