Owner's Manual

56 Using the Configuration Utility
3 Click Next to select an advertisement.
NOTE: If there is an error while applying an Integrated Dell Remote Access
Controller profile, the OS Deployment process stops.
5. Rack, Tower, or Blade
systems
Advanced LAN Settings
attributes only
All Advanced LAN
Settings attributes are
applied to Rack and
Tower systems.
Only vLAN ID and vLAN
priority attributes are
applied to Blade systems.
6. Rack, Tower, or Blade
systems
Common IP
Configuration attributes
only
Common IP
Configuration attributes
7. Rack, Tower, or Blade
systems without
iDRAC6 enterprise
card
LAN Settings with NIC
mode set to Dedicated
Nothing is applied as this
attribute needs the
iDRAC6 enterprise card.
8. Rack, Tower, or Blade
systems
LAN Settings with NIC
mode set to Shared
Attribute is applied only
to Rack and Tower
systems and only if the
host operating system is
configured for NIC
teaming.
9. Rack, Tower, or Blade
systems
IPv4 Configuration where
IP range specified is less
than the number of
systems
Nothing is applied and an
error is displayed in the
OS deployment workflow.
10. Rack, Tower, or Blade
systems booted to
Unified Server
Configurator
All four types of attributes
are configured
All attributes applicable
to the systems
Table 4-2. Integrated Dell Remote Access Controller Profile Settings
(continued)
S.No Target Server Profile Settings What is Applicable
DLCI_UserGuide.book Page 56 Tuesday, November 22, 2011 5:00 PM