Owner's Manual

Using the Configuration Utility 55
Applying an Integrated Dell Remote Access Controller Profile on a
Collection
To configure Integrated Dell Remote Access Controller and apply an
Integrated Dell Remote Access Controller profile on a collection:
1 Click Browse and select the Integrated Dell Remote Access Controller
profile that you created using the
System Viewer Utility. This profile is
applied during the hardware configuration process. For more information
on creating Integrated Dell Remote Access Controller profiles, see
Creating an Integrated Dell Remote Access Controller Profile.
2 After you select an Integrated Dell Remote Access Controller profile, you
can validate if the configuration is applied based on the following
parameters:
Table 4-2. Integrated Dell Remote Access Controller Profile Settings
S.No Target Server Profile Settings What is Applicable
1. Rack and Tower
systems
All four types of attributes
are configured.
All attributes in the
Integrated Dell Remote
Access Controller profile.
2. Blade systems All four types of attributes
are configured.
• All attributes in
Common IP settings.
• All attributes in IPv4
settings.
•
Only vLAN ID and
vLAN priority
attributes from
Advanced LAN
settings.
3. Rack, Tower, or Blade
system with Static IP
address
IPv4 Configuration
attributes only
IPv4 address source is
updated.
4. Rack, Tower, or Blade
systems
LAN Settings attributes
only
Applied only to Rack and
Tower systems and not to
Blade systems.
DLCI_UserGuide.book Page 55 Tuesday, November 22, 2011 5:00 PM