Owner's Manual

54 Using the Configuration Utility
2 If you select a simple NIC profile you can validate if all the settings in the
profile are applied on the target system by launching the Unified Server
Configurator on the target system.
3 If you select a Broadcom CNA profile you can validate if the settings are
applied based on
Ta b l e 4-1:
4 Click Next to apply an Integrated Dell Remote Access Controller profile .
NOTE: If there is an error while applying a NIC/CNA profile, the OS Deployment
process continues to the next step. While applying an attribute using ConfigUtility, it
does not check the dependent attributes value.
Table 4-1. Broadcom Profile Settings
S.No Target Server Setting Profile Settings What is Applied
1. Dual Port NIC
(partition disabled)
Dual Port NIC
Dual Port Quad Partition
NIC
Dual Port Quad Partition
NIC
Partition is enabled when
the system reboots.
2. Dual Port NIC
(partition disabled)
Dual Port NIC Dual Port NIC
Port level settings are
applied when the system
reboots.
3. Dual Port NIC
(partition disabled)
Dual Port Quad Partition
NIC
Dual Port Quad Partition
NIC
Partition is enabled when
the system reboots.
4. Dual Port Quad
Partition NIC
Dual Port NIC
Dual Port Quad Partition
NIC
Dual Port Quad Partition
5. Dual Port Quad
Partition NIC
Dual Port NIC Nothing is applied as
there is no match
between the target server
setting and profile
setting.
6. Dual Port Quad
Partition NIC
Dual Port Quad Partition
NIC
Dual Port Quad Partition
DLCI_UserGuide.book Page 54 Tuesday, November 22, 2011 5:00 PM