Owner's Manual

Using the Configuration Utility 49
2 In the Component Configuration window, right-click Out of Band
Management
and select Properties . The Out of Band Management
Properties
window appears.
3 Click the Dell Lifecycle Controller tab.
4 Under Default Share Location for Custom Lifecycle Controller Boot
Media
, click Modify to modify the default share location of the custom
Lifecycle Controller boot media.
5 In the Modify Share Information window, enter a new share name and
share path. Click
OK .
Configuring Hardware and Deploying the
Operating System
Remote operating system deployment is the ability to execute an unattended
installation of a target operating system on any auto-discovered system using
Integrated Dell Remote Access Controller.
This feature:
• Updates the firmware from a Dell repository.
• Makes changes to the hardware configuration.
• Enables you to apply a NIC or CNA profile to a set of target systems.
• Makes changes to the RAID configuration.
• Enables you to apply an Integrated Dell Remote Access Controller profile
to a set of target systems.
• Enables you to select the advertisement and the operating system to be
deployed.
• Enables you to select the bootable media to deploy the operating system.
The pre-operating system image is mounted as a virtual media over the
network and the drivers for the target host operating system are applied, 
either from the ConfigMgr console repository or the Lifecycle Controller. 
If you select drivers from the Lifecycle Controller, the list of operating
systems supported is based on the current driver pack flashed on the
Integrated Dell Remote Access Controller. You can also download an ISO
image to the vFlash SD card on the target system and boot the system to the
downloaded ISO image.
DLCI_UserGuide.book Page 49 Tuesday, November 22, 2011 5:00 PM