Owner's Manual

Using Dell Lifecycle Controller Integration 43
Editing a Variable Condition
To edit a variable condition:
1 Select the variable condition and click Var ia bl es  Edit Variable
Condition
. The Variable Condition Configuration window is displayed
where you can make changes to your variable condition.
2 Click OK to apply the variable condition, or Cancel to return to Array
Builder
.
Deleting a Variable Condition
To delete a variable condition:
1 Select the variable condition and click Var ia bl es  Delete Variable
Condition
. A message is displayed that all the attached arrays and disks
will be deleted.
2 Click Yes to delete or No to cancel.
Arrays
Array nodes include both RAID arrays and non-RAID disk groups that are
indicated by the different icons for RAID arrays and non-RAID disks. By
default, a non-RAID disk group is created when a controller is created. If the
controller configuration specifies the number of disks required, the same
number of disks is added to the non-RAID group.
Arrays can be added, modified or deleted depending on the controller
configuration and number of disks available.
Array elements contain logical drives and physical disks.
Adding a New Array
To add a new array:
1 Under a variable condition, select a variable condition and click Arrays 
New Array . The Array Settings window is displayed.
2 Set the required RAID level from the Desired RAID Level drop-down
menu.
3 On RAID levels 50 and 60, enter the span length of the array.
4 Click OK to apply the array, or Cancel to return to Array Builder .
DLCI_UserGuide.book Page 43 Tuesday, November 22, 2011 5:00 PM