Owner's Manual

Using Dell Lifecycle Controller Integration 41
• A controller in slot "X"
• Any controller with "X" disks
• Any controller with "X" disks or more
• All remaining controllers
Adding a Controller
To add a controlle r:
1 Select a controller from the list, or select an embedded controller. The
Controllers drop-down menu to your left is enabled.
2 Click Controllers  New Controller . The Controller Configuration
window is displayed.
3 Under Controller Selection Criteria , select from the following options:
• Select the controller located in slot - Enter the slot number of the
controller.
• Select any controller with < exactly, atleast > < number of > disks
attached
- Set a rule to select any controller which matches exactly, or
at least the number of disks you have selected.
• Select all remaining controllers in the system regardless of
configuration
4 Under Variable Matching Criteria , you can set a rule to apply this
configuration only if it matches certain criteria that you select. Select
Apply this configuration only when the variable to enable the rule setting
options apply.
5 Click OK .
Editing a Controller
To edit a controller:
Select the controller and click Controllers
 Edit Controller. The Controller
Configuration window is displayed where you can make changes to your
controller.
DLCI_UserGuide.book Page 41 Tuesday, November 22, 2011 5:00 PM