Owner's Manual

32 Using Dell Lifecycle Controller Integration
System Viewer Utility
The System Viewer Utility allows you to perform various operations from the
source system to a single target system discovered under All Dell Lifecycle
Controller Servers on the ConfigMgr console. This utility works on a one-to-
one relationship and you can perform the operations on target systems one at
a time.
You must change the Integrated Dell Remote Access Controller credentials of
the target system before you launch the System Viewer Utility to perform the
various tasks.
To change the Integrated Dell Remote Access Controller credentials and
launch the System Viewer Utility:
1 Under a collection, right-click on a Dell yx1x system and select Dell
Lifecycle Controller
 Launch System Viewer .
2 The iDRAC Authentication Information screen displays the default
credentials known to the ConfigMgr. Clear
Use Credentials Known to
ConfigMgr (Default)
and do any of the following:
• Do not modify the existing account - This option is selected by
default, clear this option to provide credentials else existing
credentials are maintained. Make sure that you enter the valid
credentials for Integrated Dell Remote Access Controller. You can
provide credentials authenticated on the active directory.
• Skip CA check - This option is selected by default, clear this option to
secure communication between the ConfigMgr and the target
systems. Clearing this option will check that the certificate on the
target system is issued by a trusted certificate authority (CA). Clear
this option only if you trust the target systems.
• Skip CN check - Clear this option to enhance security; authenticate
system names and prevent impersonation. The common name (CN)
need not match the host name of the target system. Clear this option
only for trusted target systems.
3 Click OK to launch the System Viewer Utility.
DLCI_UserGuide.book Page 32 Tuesday, November 22, 2011 5:00 PM