Owner's Manual

Using Dell Lifecycle Controller Integration 25
3
Using Dell Lifecycle Controller
Integration
This chapter discusses the various operations that you can perform after 
you install Dell Lifecycle Controller Integration on Microsoft System Center
Configuration Manager (ConfigMgr).
Before you begin using Dell Lifecycle Controller Integration for ConfigMgr,
ensure that the target system is auto-discovered and present in the All Dell
Lifecycle Controller Servers collection on the ConfigMgr console.
Dell Lifecycle Controller Integration for ConfigMgr enables you to perform
the following operations on all Dell systems under the All Dell Lifecycle
Controller Servers collection:
• Configure the target systems. For more information, see Configuring
Targ et Sy st em s.
• Apply drivers on the task sequence. For more information, see Applying
Drivers on the Task Sequence.
NOTE: Select the checkbox Apply Drivers from Lifecycle Controller 
if you want to apply drivers from Lifecycle Controller while deploying
operating systems.
• Create a task sequence media. For more information, see Creating a Task
Sequence Media (Bootable ISO).
•Use the System Viewer Utility on specific systems in a collection. 
For more information, see Configuration Utility.
• Use the Config Utility on a collection of Dell systems. 
For more information, see Configuration Utility.
DLCI_UserGuide.book Page 25 Tuesday, November 22, 2011 5:00 PM