Owner's Manual

14 Introduction
11 Select to install either the Dell Lifecycle Controller Utility or the Dell
Provisioning Server, or both.
Installing Both the Components
To install the DLCI for ConfigMgr on a Site Server or Admin Console:
1
From the Custom Setup screen, select both the Dell Lifecycle Controller
Utility
and the Dell Provisioning Server options and click Next .
The Custom Setup Confirmation showing both the options is displayed.
2 Click Next .
The
Dell Provisioning Service User Credentials for ConfigMgr Access
screen is displayed.
3 Perform one of the following actions:
– On a Site Server, enter an account (with required privileges) for use by
Dell Provisioning service to access ConfigMgr, on all newly discovered
systems with iDRAC, and click
Next .
– On a ConfigMgr Admin Console with IIS, enter the primary site
server name, user name, and password that is provisioned on all newly
discovered systems with iDRAC, and click
Next .
The
Dell Lifecycle Controller Utility User Credentials for iDRAC Access
screen is displayed.
4 Enter the iDRAC credentials and click Next .
The
Change Firewall Setting screen is displayed.
5 Select the Add Provision Web Site Port in the firewall exception list
option. This enables the Provisioning Server to discover the target systems
even when firewall is enabled.
NOTE: This screen is displayed only when you select the Dell Provisioning
Server in the installer.
6 Click Next .
The
Ready to Install the Program window is displayed.
7 Click Install .
The Progress bar is displayed. After installation, the completion message is
displayed.
A5_bk0.book Page 14 Monday, November 14, 2011 11:37 AM