Owner's Manual

Introduction 13
Installing DLCI for ConfigMgr
The DLCI for ConfigMgr installer contains two components — Dell
Lifecycle Controller Utility (DLCU) and Dell Provisioning Server (DPS).
DLCU is a plug-in for ConfigMgr; select this option when you have
ConfigMgr installed on a site server.
DPS is a component for provisioning dell servers into ConfigMgr. You can
install DPS on a system that meets the prerequisites for DPS; ConfigMgr
installation is not required.
You can install both the components together or install them individually on
separate systems.
It is recommended that you close ConfigMgr before installing, upgrading, or
uninstalling the DLCI for ConfigMgr.
To install DLCI for ConfigMgr:
1
Go to support.dell.com  Drivers & Downloads .
2 Select the product, which is ideally a Dell PowerEdge yx1x system.
In the server name format
yxxx ; y denotes alphabets, for example M, R, or
T; a n d
x denotes numbers.
3 Select the operating system.
4 In the Category field, select All .
5 Click Lifecycle Controller from the list displayed.
6 Click Download against the Dell Lifecycle Controller Integration option.
7 Download the DLCI_1.3.0_Axx.zip and extract the contents to a folder on
your system.
8 Double-click the Dell_Lifecycle_Controller_Integration_1.3.0.xxx . msi
package.
The
Welcome screen is displayed.
9 Click Next .
The license agreement is displayed.
10 Accept the license agreement and click Next .
The
Setup Type screen is displayed.
A5_bk0.book Page 13 Monday, November 14, 2011 11:37 AM