Owner's Manual

Troubleshooting 69
• Issue : The Create Lifecycle Controller Boot Media option may fail if you
have not specified local folder locations for the source and
destination folders.
Resolution : Ensure that the source and destination paths used are local
paths. For example,
C:\ <folder name> .
•
Issue : If the iDRAC version is older than the supported versions in any of
the target systems, the
Boot to vFlash option in the Deploy Operating
Systems workflow may fail.
Resolution : On a rack and tower server, ensure that it has iDRAC version
1.3 firmware or newer. On a blade server, ensure that it has iDRAC
version 2.2 or newer.
•
Issue : When you are deploying an operating system using the Launch
Config
utility, the advertisements of the task sequence are not displayed
on the screen.
Resolution : Ensure that you advertise against the exact collection you plan
to deploy to, as advertisements against a parent collection does not apply
to the child collection(s).
•
Issue : While deploying Microsoft Windows 2008 R2 from ConfigMgr SP1
R2 with Windows Automated Installation Kit (Windows AIK) 1.1, the
following error message is displayed:
Operation failed with 0X80070002. The system
cannot find the file specified.
Resolution : This issue occurs if you use a Windows PE 2.X based boot
image created with Windows AIK 1.X for deploying Microsoft Windows
2008 R2. Ensure that the task sequence deploying Microsoft Windows
2008 R2 uses a Windows PE 3.0 or later based boot image created with
Windows AIK 2.X or later. For more information, see the Microsoft
Technet site at
technet.microsoft.com .
•
Issue : If the target system has an older version of BIOS that does not
support a particular method, the following error message is displayed in
the DLCTaskManager.log file:
Installed BIOS version does not support this
method
.
Resolution : Update the BIOS to the latest supported version.
DLCI_UserGuide.book Page 69 Wednesday, February 2, 2011 10:49 AM