Owner's Manual

58 Using Dell Lifecycle Controller Integration (DLCI)
3 Under Controller Selection Criteria , select from the following options:
•
Select the controller located in slot - Enter the slot number of the
controller.
•
Select any controller with < exactly, atleast > < number of > disks
attached
- Set a rule to select any controller which matches exactly, or
at least the number of disks you have selected.
• Select all remaining controllers in the system regardless of
configuration
4 Under Variable Matching Criteria , you can set a rule to apply this
configuration only if it matches certain criteria that you select. Select
Apply this configuration only when the variable to enable the rule setting
options apply.
5 Click OK .
Editing a Controller
To edit a controller:
Select the controller and click Controllers
 Edit Controller. The Controller
Configuration window is displayed where you can make changes to your
controller.
Deleting a Controller
To delete a controller:
1 Select the controller and click Controllers  Delete Controller . A warning
informing that all the attached arrays and disks will be deleted is displayed.
2 Click Yes to delete or No to cancel.
NOTE: There must be at least one controller present on the server. If there is only
one controller and you delete it, a message displays that the default controller was
inserted because the last controller was deleted.
DLCI_UserGuide.book Page 58 Wednesday, February 2, 2011 10:49 AM