Owner's Manual

28 Using Dell Lifecycle Controller Integration (DLCI)
Operations on Managed Dell Lifecycle
Controllers
DLCI for ConfigMgr enables you to perform the following operations on all
Dell systems under the All Dell Lifecycle Controller Servers collection:
• Apply drivers on the task sequence. For more information, see Applying
Drivers on the Task Sequence".
NOTE: Select the checkbox Apply Drivers from Lifecycle Controller
if you want to apply drivers from Lifecycle Controller while deploying
operating systems.
• Create a task sequence media. For more information, see Creating a Task
Sequence Media (Bootable ISO).
• Use the System Viewer Utility on specific systems in a collection.
For more information, see System Viewer Utility.
• Use the Config Utility on a collection of Dell systems.
For more information, see Config Utility.
• Launch the iDRAC console by right-clicking on any system discovered
under
All Dell Lifecycle Controller Servers on the ConfigMgr console, or
any system on the Task Viewer. For more information, see Launching the
iDRAC Console.
• Use the Task Viewer to view the status of tasks handled by DLCI for
ConfigMgr. For more information, see Task Viewer.
Applying Drivers on the Task Sequence
Based on the operating system to be deployed, you can either apply drivers
from the Lifecycle Controller or the ConfigMgr repository. The drivers
in the ConfigMgr repository can be used as a fall back set.
DLCI_UserGuide.book Page 28 Wednesday, February 2, 2011 10:49 AM