Owner's Manual

18 Setup and Use
9 Click Finish to close the wizard.
Custom Installation - Dell Lifecycle Controller Utility Only
For information on component-specific requirements, see the "Component-
Specific Requirements" section.
NOTE: The Dell Lifecycle Controller Utility can be installed either on the Site Server
or on the Admin Console. Ensure that you install the Dell Lifecycle Controller Utility
on the Site Server before using it on the Admin Console.
Use the following steps to install only the Dell Lifecycle Controller Utility:
1
Follow step 1 through step 8 of the "Installing the DLCI for ConfigMgr"
section.
2 Select the Custom option.
3 In the Custom Setup screen, select Dell Lifecycle Controller Utility and
click
Next .
4 The Custom Setup Confirmation screen displays the component that you
selected. Click
Next .
5 In the Dell Lifecycle Controller Utility User Credentials for iDRAC
Access
screen, enter the user name and password for out-of-band
controller management. This account will be provisioned on the iDRAC.
6 Click Next . The Ready to Install the Program message appears.
NOTE: This screen appears only if you are installing DLCI for ConfigMgr on a
Site Server.
7 Click Install . A screen displays the progress of the installation. After the
installation is complete, the
InstallShield Wizard Completed message
appears.
8 Click Finish to close the wizard.
DLCI_UserGuide.book Page 18 Thursday, April 22, 2010 10:48 AM