Owner's Manual

Setup and Use 15

Dell Provisioning Server

• Operating system is not a Workstation

• Operating system is not Microsoft Windows 2003 64-bit

• Operating system is Microsoft Windows 2003 SP2 or later

• Either Internet Information Services (IIS)6 or IIS7 is installed

• IIS WMI compatibility is enabled on IIS7

• IIS6 WMI Metabase compatibility is enabled on IIS7

•

icacls.exe

is present

NOTE: The Dell Provisioning Server does not support Microsoft Windows 2008 R2

operating system and IIS version 7.5.

Installing the DLCI for ConfigMgr

NOTE: After a component(s) is installed, if you need to install another

component(s), it is recommended that you uninstall the existing component(s) and

reinstall with the required component(s).

NOTE: It is recommended that you read the "Software Prerequisites and

Requirements" section before proceeding with the installation.

NOTE: If your system runs out of disk space during the installation, a message

appears confirming that there is not enough disk space. It is recommended that you

abort the installation and try again, after ensuring that the required disk space is

available.

NOTE: DLCI for ConfigMgr does not support upgrading from version 1.0 to version

1.1. Uninstall version 1.0 and install version 1.1.

Use the following steps to install the DLCI for ConfigMgr:

Go to the Dell Support website at

support.dell.com

→

Drivers &

Downloads

Download the appropriate .

msi

package for your operating system to the

local drive of your system.

Download the

DLCI_1.1.0_Axx.zip

(Where xx is the DLCI version

number).

NOTE: If you are installing DLCI for ConfigMgr on a system with User Access

Control (UAC) enabled, launch the MSI file with Run As Administrator access. For

more information, see the "Installing on a UAC Enabled System" section.

DLCI_UserGuide.book Page 15 Thursday, April 22, 2010 10:48 AM