Owner's Manual

8 Setup and Use
• Utilities regsvr32.exe and icacls.exe .
NOTE: regsvr32.exe is installed on the system by default. icacls.exe is
updated when you apply the hotfix from the Microsoft KB article 947870. The
hotfix is available on the Microsoft support site at support.microsoft.com.
• Apply the hotfix from the Microsoft KB article 947870 on systems with
Microsoft Windows 2003 operating system, on which provisioning server is
installed. The hotfix is available on the Microsoft support site at
support.microsoft.com .
• Install the WS-Management version 1.1 package from the Microsoft KB
article 936059, available on the Microsoft support site at
support.microsoft.com .
• Ensure that at least 40 MB of free disk space is available on your system.
For more information on prerequisites and requirements, see the Dell™
Server Deployment Pack for Microsoft
®
System Center Configuration Manager
User’s Guide on the Dell Support website at support.dell.com/manuals.
Supported Systems and Operating Systems
For more information on supported systems and operating systems, see the
readme.txt on the Dell Support website at support.dell.com/manuals.
Installing and Uninstalling
This section lists the steps to install and uninstall the DLCI for ConfigMgr.
Installing the DLCI for ConfigMgr
NOTE: It is recommended that you read the "Prerequisites and Requirements"
section before proceeding with the installation.
NOTE: If your system runs out of disk space during the installation, a message
displays confirming that there is not enough disk space. It is recommended that you
abort the installation and try again after ensuring that the required disk space is
available.
Use the following steps to install the DLCI for ConfigMgr:
1
Go to the Dell Support website at support.dell.com → Drivers &
Downloads
.
LC_SCCM.book Page 8 Friday, October 30, 2009 11:47 AM