Owner's Manual

file:///T|/htdocs/SOFTWARE/smdlci/1_0/en/readme/Readme.txt[10/26/2012 3:12:43 PM]
Next. The Ready to Install the Program window displays.
8. Click Install. A progress screen displays the progress of the
installation.Once the installation is complete,
the InstallShield Wizard Completed window displays.
9. Click Finish to complete the installation.
You have successfully installed the DLCI for ConfigMgr.
####################################################################
KNOWN ISSUES
####################################################################
This section provides information on open issues with this
release of DLCI for ConfigMgr.
1. The Installer does not check for the patch mentioned in the
Microsoft Knowledge Base article KB947870 as a part of the
pre-requirements check. The install fails without this patch.
This does not affect uninstall or reinstall of the utility.
2. The following message is displayed when the installer
encounters the error.
“Setting Administrator level access controls failed on
<filename>. This could be due to the absence of a hotfix from
Microsoft on this system. Please refer Microsoft Knowledge
Base article KB947870 for more information and install if
required. Please uninstall the DLCI for ConfigMgr prior to
installing the hotfix.”
3. Uninstall leaves behind folders and files under
<Program Files dir>\. This does not affect reinstall of
the DLCI for ConfigMgr
4. When obsolete systems are present in a collection the DLCI
for ConfigMgr will not update results for operations performed
on these systems. It is recommended that obsolete systems be
cleaned up from collections prior to using the DLCI for
ConfigMgr.
5. When the iDRAC of the target system is in shared mode startup
of WinPE may fail. This is due to incorrect network drivers
being loaded by WinPE. The steps to correct this issue are
documented below.
-----------------------------------------------------------------------
Creating a Custom Boot Image for iDRAC’s Configured in Shared
Network Mode
-----------------------------------------------------------------------
When deploying an operating system to a server that has it’s
iDRAC configured in Shared network mode, the startup of the
Windows PE environment can fail on the network drivers,