User's Manual

Post-reboot Scenarios
The following table lists the post-reboot scenarios, its user actions, and impact.
Scenario User Action and Impact
During POST, the system prompts you to
press a key to boot into the operating
system installation media
Press any key to begin the operating system installation;
else, the system boots to the hard disk drive and not the
operating system installation media.
Operating system installation is interrupted
and the system restars before the
installation is completed.
The system prompts you to press a key to boot from the
operating system installation media.
Want to cancel operating system
installation.
Press <F10>.
NOTE: Pressing <F10> at any point during the
installation process, or while restarting, causes any
drivers provided by the OS Deployment wizard to be
removed.
During the 18-hour period when drivers are
extracted to a temporary location after the
operating system is installed, you cannot
update the component firmware by using a
DUP. If you attempt a DUP update through
the operating system during this time
period, the DUP displays a message that
another session is active.
Lifecycle Controller does not allow this after the operating
system installation. However, if you disconnect the power
supply to the managed system, the OEMDRV directory is
erased.
23