Release Notes

BITS119803 Lifecycle Controller Firmware Update from Catalog failing from CIFS & NFS.

BITS122343 Unable to locate the catalog file ERROR while updating from ftp.dell.com

BITS121343 Firmware Update Through Lifecycle Controller is unsuccessful, but FFV is being

updated.

BITS121039 For some NIC cards, NIC card name is not displayed properly in Lifecycle Controller

network settings.

BITS085364 Lifecycle Controller Port Number is not correctly specified showing duplicate port

number for Mellanox.

BITS116723 In Lifecycle Controller, remove catalog signature verification done using the LGPL

code.

BITS120812 System Setup Display issue with 64-bit Numeric Value in HII.

BITS116723 In Lifecycle Controller, remove catalog signature verification done using LGPL code

BITS114388 The Lifecycle Controller GUI has a UI problem.

BITS126663 OS to iDRAC Pass Through feature is not functional when <F2> pressed in HII mode.

BITS127059 Removing the conversion of slash in FTP

BITS122274 Lifecycle Controller is not showing the name of the chassis USB when mapped to the

M820p server.

BITS123571 Unable to set UEFI mode to deploy Windows operating system using Lifecycle

Controller.

BITS124870 Unable to clear foreign configuration during OS deployment M520p.

Important Notes



The drivers exposed by Lifecycle Controller are present in a read-only hard disk drive, labeled

OEMDRV, which are active for 18 hours. During this period:

 You cannot update any DUP.

 Lifecycle Controller cannot invoke CSIOR.

However, if an AC power cycle (cold boot) is performed, the OEMDRV drive is automatically

deleted.



To log the update events in the Lifecycle Log, make sure that the installed versions of Lifecycle

Controller and iDRAC are from the same release.



If Lifecycle Controller and iDRAC are not from the same release, the Lifecycle Log displays blank

messages and messages with a “~” character.



CPLD firmware update has no impact on Trusted Platform Module enablement.



On the basis of virtual storage device type attached through iDRAC, that is, USB drive or CD/.ISO

file, Lifecycle Controller will display Virtual Floppy or Virtual CD respectively.