Web Services Interface Guide

245 Dell Lifecycle Controller Web Services Interface Guide for Windows
-r:https://[IPADDRESS]/wsman -SkipCNcheck -SkipCAcheck -encoding:utf-8 -a:basic
–file:SetAttribute_Enumeration_RAID_Controller.xml
The input file SetAttribute_Enumeration_RAID_Controller.xml is shown below:
<p:SetAttribute_INPUT xmlns:p="http://schemas.dmtf.org/wbem/wscim/1/cim-
schema/2/root/dcim/DCIM_RAIDService">
<p:Target>RAID.Integrated.1-1</p:Target>
<p:AttributeName>RAIDBatteryLearnMode</p:AttributeName>
<p:AttributeValue>Disabled</p:AttributeValue>
</p:SetAttribute_INPUT>
OUTPUT:
SetAttribute_OUTPUT
Message = The method was successful.
MessageID = STOR001
RebootRequired = Yes
ReturnValue = 0
SetResult = Set Pending Value
16.19.2 Changing Multiple Values of RAID Controller Enumeration Attributes
The SetAttributes() method is used to set or change multiple values of RAID controller or virtual disk
attributes. The following example shows setting multiple virtual disk attributes. To set multiple controller
attributes, use the FQDD of the controller for the Target, and the AttributeName and AttributeValue.
Invoke SetAttributes() with the following parameters (from Section 16.1) and syntax:
TARGET: Obtained from the FQDD field
AttributeName: Obtained from the AttributeName field
AttributeValue: Obtained from the PossibleValues field
EXAMPLE:
winrm i SetAttributes cimv2/root/dcim/DCIM_RAIDSe
rvice?SystemCreationClassName=DCIM_ComputerSystem+CreationClassName=DCIM_RAIDSer
vice+System Name=DCIM:ComputerSystem+Name=DCIM:RAIDService
-u:[USER] -p:[PASSWORD]