Web Services Interface Guide

194 Dell Lifecycle Controller Web Services Interface Guide for Windows
InstanceID = NIC.Integrated.1-1-3:iScsiOffloadMode
IsReadOnly = false
PendingValue = null
PossibleValues = Disabled, Enabled
PossibleValuesDescription = Disabled, Enabled
15.10 Setting the IscsiOffloadMode Attribute
The SetAttribute() method is used to set or change the value of a CNA attribute. Enable the NICMode,
IscsiOffloadMode, and FcoeOffloadMode personality attributes to enable the corresponding personalities:
NIC, ISCSI, and FCOE.
For Broadcom CNA cards, the partitions on each port can be set to any personality. NICMode can always
be enabled or disabled for any of the given partitions. For the IscsiOffloadMode and FcoeOffloadMode
personalities, up to two personalities can be enabled on each port.
For the Qlogic CNA cards, partition three can be set to either NICMode or IscsiOffloadMode. Partition four
can be set to either NICMode or FcoeOffloadMode.
Invoke the SetAttribute() method with the following parameters (from Section 15.1) and syntax:
Target: FQDD attained through DCIM_NICEnumeration
AttributeName: Attained from AttributeName field
AttributeValue: A new value to assign to the specified NICAttribute. If this value is valid, it is applied to the
PendingValue property or the Currentvalue property of the specified NICAttribute. Possible choices are
attained from PossibleValues field, such as:
Possible values: Disabled, Enabled
EXAMPLE:
winrm i SetAttribute http://schemas.dmtf.org/wbem/wscim/1/cim-
schema/2/root/dcim/DCIM_NICService ?SystemCreationClassName=DCIM_ComputerSystem
+CreationClassName=DCIM_NICService +SystemName=DCIM:ComputerSystem
+Name=DCIM:NICService -u:[USER] -p:[PASSWORD]
-r:https://[IPADDRESS]/wsman -SkipCNcheck -SkipCAcheck -encoding:utf-8 -a:basic
-file:SetAttribute_NIC.xml
The information in the input file SetAttribute_NIC.xml is shown below: