Web Services Interface Guide

160 Dell Lifecycle Controller Web Services Interface Guide for Windows
ReferenceParameters
ResourceURI = http://schemas.dell.com/wbem/wscim/1/cim-
schema/2/DCIM_LifecycleJob
SelectorSet
Selector: InstanceID = JID_001270734913, __cimnamespace = root/dcim
ReturnValue = 0
If this method returns the following message, the VFlash must be enabled using the VFlashStateChange() (
Section 13.3) method.
CreatePartition_OUTPUT
Message = VFlash not enabled
MessageID = VF015
ReturnValue = 2
13.5 Create Partition using Image
This method creates a partition on the storage device using the image provided by the user. The partition
size will be the same as the size of the image. The maximum size of the image is 4GB.
The image can be located on a NFS/CIFS share or on a TFTP server. When this method is successfully
executed, an instance of DCIM_OpaqueManagementData representing the desired partition will be
created (Section 13.1), and a reference to this instance is captured in the output parameter Job.
Invoke CreatePartitionUsingImage() with the following parameters and syntax:
PartitionIndex: The PartitionIndex property of the DCIM_OpaqueManagementData instance that
represents the partition to be formatted.
1 to 16
PartitionType: The format types that these partitions need to be formatted as floppy=1, hard disk=2, CD
ROM=3.
OSVolumeLabel: The label seen in the OS after attaching the partition.
URI: The URI location of firmware to update a component. Supported protocols are FTP and HTTP.
IPAddress: IP address of TFTP or NFS share
ShareType: Type of share
NFS=0, TFTP=1, CIFS=2, FTP=3, HTTP=4