Technical White Paper

le/anonymous</a:Address>
<a:ReferenceParameters>
<w:ResourceURI>http://schemas.dell.com/wbem/wscim/1/cim-
schema/2/DCIM_SoftwareIdentity</w:ResourceURI>
<w:SelectorSet>
<w:Selector Name="InstanceID">[InstanceID]</w:Selector>
</w:SelectorSet>
</a:ReferenceParameters>
</p:Target>
</p:InstallFromSoftwareIdentity_INPUT>
OUTPUT:
When this method is executed, a jobid or a message is displayed indicating an error.
<n1:InstallFromSoftwareIdentity_OUTPUT>
<n1:Job>
<wsa:Address>http://schemas.xmlsoap.org/ws/2004/08/addressing/role/anon
ymous</wsa:Address>
<wsa:ReferenceParameters>
<wsman:ResourceURI>http://schemas.dell.com/wbem/wscim/1/cimschema
/
2/DCIM_SoftUpdateConcreteJob</wsman:ResourceURI>
<wsman:SelectorSet>
<wsman:Selector
Name="InstanceID">JID_001299753229</wsman:Selector>
<wsman:Selector Name="__cimnamespace">root/dcim</wsman:Selector>
</wsman:SelectorSet>
</wsa:ReferenceParameters>
</n1:Job>
<n1:ReturnValue>4096</n1:ReturnValue>
</n1:InstallFromSoftwareIdentity_OUTPUT>
7.4 NIC Firmware “Rollback”
The InstallFromSoftwareIdentity() method is used for installation of a earlier version of a component
firmware that is available on the Lifecycle Controller (that is “rollback” of component firmware).
Invoke InstallFromSoftwareIdentity with the following parameters and syntax:
[InstanceID]: This is the instanceID of the SoftwareIdentify that is to be used to rollback the
firmware to a earlier version. The InstanceID can have the following value:
DCIM:PREVIOUS:PCI:14E4:1639:0237:1028
• It refers to a earlier firmware on a PCI device.
• ID (Vendor ID)= 14E4
• DID (Device ID) = 1639
• SSID (Subsystem ID) = 0237
• SVID (Subvendor ID) = 1028
• This refers to a Broadcom NetXtreme II BCM5709 network adaptor 7.
EXAMPLE:
wsman invoke -a InstallFromSoftwareIdentity
http://schemas.dmtf.org/wbem/wscim/1/cimschema/
2/root/dcim/DCIM_SoftwareInstallationService