Technical White Paper
wsman invoke -a ApplyAttributes
"http://schemas.dmtf.org/wbem/wscim/1/cimschema/
2/root/dcim/DCIM_
iDRACCardService
?SystemCreationClassName=DCIM_ComputerSystem,
CreationClassName=DCIM_iDRACCardService,SystemName=DCIM:ComputerSystem,Name=D
CIM:iDRACC
ardService"
-h $IPADDRESS -V -v -c dummy.cert -P 443
-u $USERNAME -p $PASSWORD -j utf-8 -y basic -J DracCard_AccountChange.xml
The input file, DracCard_ AccountChange.xml, is shown below:
<p:ApplyAttributes_INPUT
xmlns:p="http://schemas.dmtf.org/wbem/wscim/1/cim-
schema/2/root/dcim/DCIM_iDRACCardService">
<p:Target>iDRAC.Embedded.1</p:Target>
<p:AttributeName>Users.4#Enable</p:AttributeName>
<p:AttributeValue>Enabled</p:AttributeValue>
<p:AttributeName>Users.4#Password</p:AttributeName>
<p:AttributeValue>PASSWORDHERE</p:AttributeValue>
</p:ApplyAttributes_INPUT>
OUTPUT:
When this method is executed, a
jobid
or a message is displayed indicating an error.
ApplyAttributes_OUTPUT
<n1:ApplyAttributes_OUTPUT>
<n1:Job>
<wsa:Address>http://schemas.xmlsoap.org/ws/2004/08/addressing/role/anon
ymous</wsa:Address>
<wsa:ReferenceParameters>
<wsman:ResourceURI>http://schemas.dell.com/wbem/wscim/1/cimschema/
2/DCIM_LifecycleJob</wsman:ResourceURI>
<wsman:SelectorSet>
<wsman:Selector Name="InstanceID">JID_001299683957</wsman:Selector>
<wsman:Selector
Name="__cimnamespace">root/dcim</wsman:Selector>
</wsman:SelectorSet>
</wsa:ReferenceParameters>
</n1:Job>
<n1:ReturnValue>4096</n1:ReturnValue>
</n1:ApplyAttributes_OUTPUT>
The following error may result if the password has not initially been set to a value. The password may
be set an initail value at the same time as the account is enabled by adding the
Users.4#Password
attribute name and corresponding attribute value, as shown above.
<n1:ApplyAttributes_OUTPUT>
<n1:Message>The User Password is not configured so cannot Enable the
User or set values for
User Password IPMILan IPMISerial or User Admin Privilege</n1:Message>
<n1:MessageArguments>NULL</n1:MessageArguments>
<n1:MessageID>RAC023</n1:MessageID>
<n1:ReturnValue>2</n1:ReturnValue>
</n1:ApplyAttributes_OUTPUT>