Technical White Paper

AttributeName: Attained from AttributeName field
AttributeValue: A new value assigned to the specified NICAttribute . If this value is valid, it
will be applied to the PendingValue property or the Currentvalue property of the specified
NICAttribute . Possible selections are attained from PossibleValues field.
EXAMPLE:
wsman invoke -a SetAttributes http://schemas.dmtf.org/wbem/wscim/1/cimschema/
2/root/dcim/DCIM_NIC
Service?SystemCreationClassName=DCIM_ComputerSystem,CreationClassName=DCIM_NI
CService,Syst
emName=DCIM:ComputerSystem,Name=DCIM:NICService -h $IPADDRESS -V -v -c
dummy.cert -P 443 -u
$USERNAME -p $
PASSWORD -J SetAttributes_NIC_LAN_Modes.xml -j utf-8 -y basic
The input file SetAttributes_NIC.xml is shown below:
<p:SetAttributes_INPUT
xmlns:p="http://schemas.dmtf.org/wbem/wscim/1/cim-
schema/2/root/dcim/DCIM_NICService">
<p:Target>NIC.Embedded.1-1</p:Target>
<p:AttributeName>LegacyBootProto</p:AttributeName>
<p:AttributeValue>PXE</p:AttributeValue>
<p:AttributeName>LnkSpeed</p:AttributeName> <p:AttributeValue>10Mbps
Half</p:AttributeValue> <p:AttributeName>WakeOnLan</p:AttributeName>
<p:AttributeValue>Disabled</p:AttributeValue>
<p:AttributeName>VLanMode</p:AttributeName>
<p:AttributeValue>Enabled</p:AttributeValue>
<p:AttributeName>IscsiTgtBoot</p:AttributeName> <p:AttributeValue>One
Time Disabled</p:AttributeValue>
</p:SetAttributes_INPUT>
OUTPUT:
<n1:SetAttribute_OUTPUT>
<n1:Message>The command was successful</n1:Message>
<n1:MessageID>NIC001</n1:MessageID>
<n1:RebootRequired>Yes</n1:RebootRequired >
<n1:ReturnValue>0</n1:ReturnValue>
<n1:SetResult>Set PendingValue</n1:SetResult >
</n1:SetAttribute_OUTPUT>
15.15 Setting the iSCSI Boot Target
The SetAttributes() method is used to set or change the values of the iSCSI boot target attributes.
Invoke the SetAttributes() method with the following parameters (from 15.1) and syntax:
Target: FQDD attained through DCIM_NICEnumeration
AttributeName: Attained from AttributeName field
AttributeValue: A new value to assigned the specified NICAttribute . If this value is valid, it is
applied to the PendingValue property or the Currentvalue property of the specified
NICAttribute . Possible selections are attained from PossibleValues field, such as: