Setup guide

8 Configuring VLAN Settings in Lifecycle Controller for Dell PowerEdge Servers
2. In the left pane, click Settings, and then click Network Settings.
Figure 4 LC GUI Settings Page
1.2.1 Setting DHCP Server as the IP Address Source
1. From the NIC Card drop-down menu, select a NIC card.
2. From the IP Address drop-down menu, select DHCP.
3. To type a priority level and VLAN ID within the specified value, under Lifecycle Controller VLAN
Settings, select Enable.
Note: Make sure network cable is connected to a NIC card which is selected for VLAN settings.