Release Notes

(on CIFS share) through LC GUI.
BITS072349 <LC2><View License>RSOD when the License Information link on the About page
is clicked multiple times.
BITS071031 LC2: Demo comments on VLAN support-2/28.
BITS079114 LC 2: PM DUP update is unsuccessful indicating that the DUP is not supported.
BITS078683 LC2: LC should fetch latest Catalog file from ftp.dell.com and also check the
Catalog folder first.
BITS070158 LC2: LC should show the Catalog Version when user performs update
from ftp.dell.com
BITS073175 Espada1.4-Updates: NIC updates time out with LC or the iDRAC GUI
& CPU Exception error is in LCL.
Important Notes
 The drivers exposed by Lifecycle Controller are present in a read-only hard disk drive, labeled
OEMDRV, which are active for 18 hours. During this period:
 You cannot update any DUP.
 Lifecycle Controller cannot invoke CSIOR.
However, if an AC power cycle (cold boot) is performed, the OEMDRV drive is automatically
deleted.
 To log the update events in the Lifecycle Log, make sure that the installed versions of Lifecycle
Controller and iDRAC are from the same release.
 If Lifecycle Controller and iDRAC are not from the same release, the Lifecycle Log displays blank
messages and messages with a “~” character.
 CPLD firmware update has no impact on Trusted Platform Module enablement.
 On the basis of virtual storage device type attached through iDRAC, that is, USB drive or CD/.ISO
file, Lifecycle Controller will display Virtual Floppy or Virtual CD respectively.
Known Issues
Issue 1
Description
If FlexAddress is enabled on Chassis Management Controllers, iDRAC and Lifecycle Controller do not
display the same MAC addresses.
Resolution
To view the chassis-assigned MAC address, use the iDRAC Web interface or the CMC Web interface. Go
to General-> Network Settings.
Versions Affected
All the LC2–supported Dell PowerEdge servers.