Practices Guide

Lifecycle Controller Integration―Best Practices Specification

Results for the InstanceID of DCIM:iDRACCard:1.0.0 shown below. If no instance is returned, the

profile is not supported.

DCIM_LCRegisteredProfile

AdvertiseTypeDescriptions = WS-Identify

AdvertiseTypeDescriptions = Interop Namespace

AdvertiseTypes = 1

InstanceID = DCIM:iDRACCard:1.0.0

OtherRegisteredOrganization = DCIM

ProfileRequireLicense = Remote Firmware Configuration

ProfileRequireLicense = Remote Inventory

ProfileRequireLicense = Virtual Console

ProfileRequireLicense = Virtual Media

ProfileRequireLicense = Two-Factor Authentication

ProfileRequireLicense = Directory Services

ProfileRequireLicense = IPv6

ProfileRequireLicense = Dynamic DNS

ProfileRequireLicenseStatus = LICENSED

RegisteredName = iDRAC Card

RegisteredOrganization = 1

RegisteredVersion = 1.2.0

9.2 Get all iDRAC Card Attributes

Use the following procedure below to list all of the attributes from all of the iDRAC Card class

in the system.

Applies to: LC1.5.0+

Prerequisites for script: none

Script: GetAlliDRACCardAttributes.win

A) The Lifecycle Controller remote service must be in a “ready” state before executing any

other WSMAN commands. The GetRSStatus() method or the GetRemoteServicesAPIStatus()

method may be used depending on the version of the LC Management registered profile.

B) GetiDRACCardAttributes(): ENUMERATE the DCIM_iDRACCardAttribute class to view all

attributes. See section 2.2 for a definition of

ENUMERATE .

9.3 Inventory of iDRAC Cards in System

Use the following procedure below to list the inventory of all iDRAC Cards in the system.