Practices Guide

Lifecycle Controller Integration―Best Practices Specification
124
Script: GetVideoView.win
A) The Lifecycle Controller remote service must be in a “ready” state before executing any
other WSMAN commands. The GetRSStatus() method or the GetRemoteServicesAPIStatus()
method may be used depending on the version of the LC Management registered profile.
B) GetVideoView(): GET the DCIM_VideoView instance using the InstanceID=
Video.Embedded.1-1. See Section 2.3 for a definition of
GET.
The instance of DCIM_VideoView that contains the information will be returned.
26 License Management Profile Use Cases
26.1 Discovery of License Management Profile Support
Use the following procedure below to confirm the existence of License Management profile
support.
Applies to: LC2+
Prerequisites for script: none
Script: GetLicenseManagementProfile.win
A) The Lifecycle Controller remote service must be in a “ready” state before executing any
other WSMAN commands.
GetRemoteServicesAPIStatus():
B) GetLCRegisteredProfiles(): ENUMERATE the DCIM_LCRegisteredProfile class to view all
registered profiles. See section 2.2 for a definition of
ENUMERATE .
C) Search for “RegisteredName= License Management” and note its instanceID to use in step
D)
D) GetLCRegisteredProfile(): GET the DCIM_LCRegisteredProfile instance using the
InstanceID from C). See Section 2.3 for a definition of
GET.
Results for the InstanceID of DCIM:LicenseManagement:1.0.0 shown below. If no instance is
returned, the profile is not supported.
DCIM_LCRegisteredProfile
AdvertiseTypeDescriptions = WS-Identify
AdvertiseTypeDescriptions = Interop Namespace
AdvertiseTypes = 1
AdvertiseTypes = 1
InstanceID = DCIM:LicenseManagement:1.0.0
OtherRegisteredOrganization = DCIM
ProfileRequireLicense = Licensing Management