Practices Guide

Lifecycle Controller Integration―Best Practices Specification
113
D) GetLCRegisteredProfile(): GET the DCIM_LCRegisteredProfile instance using the
InstanceID from C). See Section 2.3 for a definition of
GET.
Results for the InstanceID of DCIM: SoftwareUpdate:1.0.0 shown below. If no instance is
returned, the profile is not supported.
DCIM_LCRegisteredProfile
AdvertiseTypeDescriptions = WS-Identify
AdvertiseTypeDescriptions = Interop Namespace
AdvertiseTypes = 1
AdvertiseTypes = 1
InstanceID = DCIM:SoftwareUpdate:1.0.0
OtherRegisteredOrganization = DCIM
ProfileRequireLicense = Remote Firmware Update
ProfileRequireLicenseStatus = LICENSED
RegisteredName = Software Update
RegisteredOrganization = 1
RegisteredVersion = 1.0.0
20 Job Control Profile Use Cases
20.1 Discovery of Job Control Profile Support
Use the following procedure below to confirm the existence of Job Control profile support.
Applies to: LC1.4.0+
Prerequisites for script: none
Script: GetJobControlProfile.win
A) The Lifecycle Controller remote service must be in a “ready” state before executing any
other WSMAN commands. The GetRSStatus() method or the GetRemoteServicesAPIStatus()
method may be used depending on the version of the LC Management registered profile.
B) GetLCRegisteredProfiles(): ENUMERATE the DCIM_LCRegisteredProfile class to view all
registered profiles. See section 2.2 for a definition of
ENUMERATE .
C) Search for “RegisteredName=Job Control” and note its instanceID to use in step D)
D) GetLCRegisteredProfile(): GET the DCIM_LCRegisteredProfile instance using the
InstanceID from C). See Section 2.3 for a definition of
GET.
Results for the InstanceID of DCIM:JobControl:1.0.0 shown below. If no instance is returned,
the profile is not supported.
DCIM_LCRegisteredProfile
AdvertiseTypeDescriptions = WS-Identify
AdvertiseTypeDescriptions = Interop Namespace
AdvertiseTypes = 1
AdvertiseTypes = 1
InstanceID = DCIM:JobControl:1.0.0
OtherRegisteredOrganization = DCIM