Owner's Manual

Issue 3
Description
While deploying Windows Server 2008 R2 SP1 from OS Deployment of Lifecycle Controller, installation
stops with the following error:
There is no disk in the drive. Please insert a disk into drive \Device\Harddisk0\DR0.
This issue may occur due to any of the following reasons:
 Virtual Media is in the attached state, with no media mapped.
 Virtual Media is in the auto-attached state, with media mapped.
 Virtual Media being presented by the AVCT SIP and Virtual Media from iDRAC7 in the detached
state.
 The underlying cause may be due to failure to load drivers for RAID controllers on the system.
NOTE: It does not occur with Virtual Media in the detached state. It also does not occur without the SIP
and with Virtual Media in the detached from iDRAC7.
Resolution
Retry the operation.
Versions/Systems Affected
Lifecycle Controller 2 version 1.1.5
Issue 4
Description
Some of the supported components are not displayed on the Firmware Update-> View Current
Versions page.
Resolution
Reboot the system and open View Current Versions page.
Versions/Systems Affected
All
Issue 5
Description
For an Intel Ethernet X520 10GbE Dual Port KX4-KR Mezzanine card, after the firmware is downgraded
from version 14.0.12 to version 13.5.6, the View Current Versions page displays the firmware version for
the card as 5.6 instead of 13.5.6.
Resolution
Update the firmware by running the Update Package through the operating system.
Versions/Systems Affected
Lifecycle Controller 2 version 1.1.5