Read me

Open Issues and Resolutions
Fixed Issues/def
Issue 1
Description
When the user deploys RHEL version 6.1 operating system in UEFI mode, although the operating system is installed, the
drivers in the OEMDRV drive are not installed.
Resolution
To install the RHEL version 6.1 drivers:
1. Start the operating system installation through Lifecycle Controller.
2. After the operating system media boots, press [Tab ].
3. For installation in BIOS mode: Type the command line argument [ space ] followed by the string dd updates . For
installation in UEFI mode: Press a and type the string dd updates .
4. Press [ Enter ] to start the installation.
5. During installation, a Driver Disk popup appears with the message - Do you have a driver disk?.
6. Select Yes and provide the location of the driver disk.
NOTE: In some cases, the driver disk is automatically detected. If the disk is detected, skip this step, select No ,
and follow the on-screen instructions to complete the installation.
7. Select the driver disk drive (OEMDRV).
8. Select the file driver_disk.iso to load the drivers.
9. A Update Disk Source popup appears with the message to select the location of the update source.
10. Select the OEMDRV partition and press OK .
The Updates Disk popup appears.
11. Press OK and follow the on-screen instructions to complete the installation.
Versions Affected
All
Issue 2
Description
During the RHEL version 6.1 installation, the installer tries to create a mount point ( \boot\efi ) on any exposed vFAT
partition. However, since the exposed vFAT partitions on Lifecycle Controller are read-only, the installation fails.