Users Guide
– View Only
– Disable
5. Click Finish to apply the changes.
System Control Panel Access Options
Lifecycle Controller front panel security configuration enables an administrator to restrict access to control panel
interface. The options available are:
• View and Modify — You can obtain information and make changes using the system control panel interface.
• View Only — You can move through the data screens to obtain information using the system control panel
interface.
• Disabled — You do not have access to information or control, other than the information displayed by the
management controller, and you cannot specify actions.
Configuring System Time And Date
To set the time and date for the managed system:
1. From the Lifecycle Controller Home page, select Hardware Configuration.
2. In the right pane, select Configuration Wizards.
3. Under System Configuration Wizards, click System Time/Date Configuration.
The default system time and system date shown in Lifecycle Controller is the date and time reported by the system
BIOS.
4. Modify the System Time and System Date (HH:MM:SS AM/PM), as required.
5. Click Finish to apply the changes.
Configuring iDRAC
To configure iDRAC parameters applicable to the system, such as LAN, common IP settings, IPv4, IPv6, Virtual Media,
and LAN user configuration use the iDRAC Configuration Wizard.
To configure and manage iDRAC parameters:
1. In the left pane of Home page, click Hardware Configuration.
2. In the right pane, click Configuration Wizards.
3. Under System Configuration Wizards, click iDRAC Configuration, and configure the following parameters.
– LAN Configuration
– Advanced LAN Configuration
– Common IP Configuration
– IPv4 Configuration
– IPv6 Configuration
– Virtual Media Configuration
– LAN User Configuration
4. In the Summary page, view the summary of all the changes, and click Apply to save the changes.
A Please Wait message appears while your changes are saved. When the operation is complete, a final
Confirmation screen displays a table with the three values: Unchanged, Success, or Failed for all the modified
parameters.
35