Release Notes

 System Characterization must be enabled to correctly run the firmware update during system power on after a
Power Supply Unit (PSU) replacement. If System Characterization is not enabled, the firmware update runs after
the next host reboot.
 If the system is shut down or left in the shutdown state while a job is in progress, the job cannot progress further.
Delete the job and run it again.
LC2-RS - Open Issues and Resolutions
Issue 1
Description
When the status of the DUP update is checked using the WS-MAN query for the job InstanceID of the DCIM_LifecycleJob, the
'Percentage Complete' parameter value displays 'NA' even though the job is in-progress or complete.
Versions/Systems Affected
All LC2-RS supported Dell PowerEdge systems.
Issue 2
Description
After running a BIOS or NIC job, if you pause (by pressing Pause key on keyboard) during POST and run another BIOS or NIC
job, it fails.
Versions/Systems Affected
All LC2-RS supported Dell PowerEdge systems.
Issue 3
Description
While performing platform update using the NFS share option, if the NFS service is stopped or network connection to the
NFS share is lost while the job is in a downloading state, the job does not fail and continues to stay in a downloading state.
Resolution
To change the job status to:
 Downloaded successfully - Restart the NFS service or re-establish the network connection.
 Failed - Reset iDRAC7.
Versions/Systems Affected
All LC2-RS supported Dell PowerEdge systems.