Users Guide

Step Number Location in Lifecycle Controller Web Services Interface Guide (Windows or Linux)
• DCIM_iDRACCardInteger.mof
• DCIM_iDRACCardService.mof
• DCIM_iDRACCardString.mof
• DCIM_iDRACCardView.mof
iDRAC Attributes
Using Remote Services, you can set the iDRAC attributes listed in the following tables.
Table 18. LAN Attributes
Attribute Description Values
VLAN Enabled Indicates the VLAN mode of operation and
parameters. When VLAN is enabled, only
matched VLAN ID traffic is accepted. When
disabled, VLAN ID and VLAN Priority are not
available, and any values present for those
parameters are ignored.
Enable or Disable
VLAN ID Sets the VLAN ID value. Legal values are
defined by IEEE 801.11g specification.
1 to 4094
VLAN Priority Sets the VLAN ID priority value. Legal values
are defined by IEEE 801.11g specification.
0 to 7
Auto Negotiate When auto-negotiate is on, it determines
whether iDRAC automatically sets the Duplex
Mode and Network Speed values by
communicating with the nearest router or
hub. When auto-negotiate is off, you must set
the Duplex Mode and Network Speed values
manually.
On or Off
LAN Speed Configures the network speed to match the
user's network environment. This option is
not available if Auto-Negotiate is set to On.
10 MB or 100MB
LAN Duplex Configures the duplex mode to match the
user's network environment. This option is
not available if Auto- Negotiate is set to On.
Full or Half
Table 19. LAN User Configuration
Attribute Description Value
Auto-Discovery Auto discovery of server. Enable or Disable
Provisioning Server
Address
Enter Provisioning server address. IPV4 or IPV6 or Host Name
Account Access Disabling account access deactivates all
other fields on the LAN User Configuration.
Enable or Disable
Account Username Enables the modification of an iDRAC user
name.
Maximum of 16 printable ASCII characters
Password Enables an administrator to specify or edit
the iDRAC user's password (Encrypted).
Maximum of 20 characters
70