Users Guide

10. You can query the status of the job ID output using the job control profile methods.

11. Repeat

step 4

to confirm successful execution of the method.

References For Changing Personality

NOTE: The sections referenced in this table contain only generic examples.

Table 13. Step Number and Location

Step Number Location in Lifecycle Controller Web Services Interface Guide (Windows or Linux)

step 1 15.1 — Listing the CNA Inventory-Enumeration Class

step 2 15.14 — Setting CNA LAN Modes

step 4 15.3 — Listing CNA Inventory-Integer Class

step 5 15.11 — Setting the MaxBandwidth Attribute

step 6 15.3 — Listing CNA Inventory-Integer Class

step 7 15.7 — Applying the Pending Values for CNA-CreateTargetedConfigJob()

step 8 15.5 — Applying the Pending Values for CNA-CreateTargetedConfigJob()

step 9 7.8 — CreateRebootJob()

10.2.1 — Setup Job Queue

step 10 10.2.3 — List Jobs in Job Store

Profiles

Simple NIC Profile document at delltechcenter.com/page/DCIM.Library

MOFs

• DCIM_NICView

• DCIM_NICString

• DCIM_NICEnumeration

• DCIM_NICInteger

• DCIM_NICAttribute

• DCIM_NICService

Setting the Virtual Address Attributes

To successfully perform remote operations on the server, make sure that the prerequisites provided in the Common

Prerequisites Before Using Remote Services are met.

Change the virtual address attribute on a CNA card.

NOTE: All virtual address attributes are reset to default if the system is disconnected from AC power supply.

Set the appropriate values to each of the following virtual address attributes:

• VirtMacAddr

• VirtIscsiMacAddr

• VirtFIPMacAddr

• VirtWWN

• VirtWWPN