Users Guide

RAID Setup-Post Configuration Scenario

1. Get the job status using the job ID generated earlier.

2. To check if the RAID configuration and the local key based controller encryption enablement are successful, you

must verify if the system automatically boots to Lifecycle Controller and applies the RAID configuration change and

the local key.

3. Get the job status using the job ID generated earlier for which this status message is returned Job completed

successfully.

4. Repeat step 1 and step 2 and verify if the changes are applied.

References For Configuring RAID

NOTE: The sections referenced in this table contain only generic examples.

Table 10. Step Number and Location

Step Number Location in Lifecycle Controller Web Services Interface

Guide (Windows or Linux)

step 1 16.7 — Listing the RAID Inventory-ControllerView Class

step 2 16.9 — Listing the RAID Inventory-PhysicalDiskView Class

step 3 16.18.5 — Creating a Sliced Virtual Disk-CreateVirtualDisk

step 4 16.18.5 — Creating a Sliced Virtual Disk-CreateVirtualDisk

step 5 16.10 — Listing the RAID VirtualDiskView Inventory

step 6 16.17.3 — Locking the Controller with a Key-

EnableControllerEncryption

step 7 16.16.2 — Assigning the Hot Spare-AssignSpare()

step 8 16.14 — Applying the Pending Values for RAID-

CreateTargetedConfigJob

step 9 16.14 — Applying the Pending Values for RAID-

CreateTargetedConfigJob

Profiles

DCIM-SimpleRAIDProfile

MOFs

• DCIM_ControllerView.mof

• DCIM_EnclosureView.mof

• DCIM_PhysicalDiskView.mof

• DCIM_RAIDAttribute.mof

• DCIM_RAIDEnumeration.mof

• DCIM_RAIDInteger.mof

• DCIM_RAIDService.mof

• DCIM_RAIDString.mof

• DCIM_VirtualDiskView.mof