User's Manual

IRQ stack
<binary data>
UNDEF stack
<binary data>
ABORT stack
<binary data>
SVC stack
<binary data>
SWI stack
<binary data>
Enter stack
<binary data>
Current task stack: 'IPEV' -#005e0000
<binary data>
where <binary data> is the binary information that was generated by the DRAC 4 firmware.
Example output (when data is not available):
FW d_cmdCoreDump: No CORE dump available.
coredumpdelete
TableA-7 describes the coredumpdelete subcommand.
Table A-7. coredumpdelete

Synopsis
racadm coredumpdelete

Description
The coredumpdelete command clears the area reserved for persistent storage of bus error information. This operation is performed regardless of whether any
bus error information is currently stored in the area reserved for this information.
See the coredump command for information about displaying the bus error information.
fwupdate
TableA-8 describes the fwupdate subcommand.
Table A-8. fwupdate
NOTE: To use this command, you must have Clear Logs or Execute Debug Commands permission.

Subcommand

Definition
coredumpdelete
Deletes the core dump stored in the DRAC 4.
NOTE: To use this command, you must have Configure DRAC 4 permission.

Subcommand

Definition