User's Manual

l racadcm racreset soft 1
Start the DRAC 4 soft reset sequence in 1 second.
l racadm racreset soft 20
Start the DRAC 4 soft reset sequence after 20 seconds.
racresetcfg
TableA-22 describes the racresetcfg subcommand.
Table A-22. racresetcfg

Synopsis
racadm racresetcfg

Description
The racresetcfg command removes all database property entries that have been configured by the user. The database has default properties for all entries
that are used to restore the card back to its original default settings. After resetting the database properties, the DRAC 4 resets automatically.
serveraction
TableA-23 describes the serveraction subcommand.
Table A-23. serveraction

Synopsis
racadm serveraction [-d <delay>] <action>

Description
The serveraction command provides an interface to control system reset and power control. TableA-24 describes the serveraction subcommand option
values.
Table A-24. serveraction Subcommand Options
NOTE: To use this command, you must have Configure DRAC 4 permission.

Subcommand

Definition
racresetcfg
Resets all database configuration parameters to default values; equivalent to a soft reset.
NOTICE: Before using this command, ensure that you want to restore your database to its original default state with default user root and default
password calvin.
NOTE: After issuing a racresetcfg subcommand, stop and then restart the following services: Server Agent, Server Agent Event Monitor, and SNMP. See
the Dell OpenManage Server Administrator's User's Guide for information on stopping and restarting the services in your operating system.
NOTE: To use this command, you must have Execute Server Control Commands permission.

Subcommand

Definition
serveraction
Executes a managed system reset or power-on/off/cycle.

String

Definition
<action>
Specifies the action. The options for the <action> string are:
l powerdown – Powers down the system.
l powerup – Powers up the system.