User's Manual

l The -o option disables the Ethernet management port completely.
<ipAddress>, <netmask>, and <gateway> must be typed as dot-separated strings.

Description for getniccfg
The getniccfg subcommand displays the current Ethernet management port settings

Output
The setniccfg subcommand returns without output if successful. The getniccfg subcommand output displays the following information:
Network adapter = Enabled/Disabled
DHCP = Enabled/Disabled
Static IP Settings: <ipAddress> <netmask> <gateway>
Current IP Settings: <ipAddress> <netmask> <gateway>
getsvctag
TableA-18 describes the getsvctag subcommand.
Table A-18. getsvctag

Synopsis
racadm getsvctag

Description
The getsvctag subcommand displays the Service Tag for the system.

Example
Type getsvctag at the command prompt. The output is displayed as follows:
Y76TP0G
The command returns 0 on success and nonzero on errors.
racdump
TableA-19 describes the racdump subcommand.
Table A-19. racdump

Synopsis
NOTE: To use this command, you must have Log In To DRAC 4 permission.

Subcommand

Definition
getsvctag
Displays a service tag.
NOTE: To use this command, you must have Log In DRAC 4 permission.

Subcommand

Definition
racdump
Displays status and general DRAC 4 information.