User's Manual

getractime
TableA-16 describes the getractime subcommand.
Table A-16. getractime

Synopsis
racadm getractime [-u] [-d]

Description
The getractime subcommand displays the time in one of the following two formats:
l u – The UTC hexidecimal value followed by the offset in signed decimal (default).
l d – The yyyymmddhhmmss.mmmmmmsoff string with no option is displayed in the same format as the UNIX®date command.

Output
The getractime subcommand displays the output on one line.
setniccfg/getniccfg
TableA-17 describes the setniccfg and getniccfg subcommands.
Table A-17. setniccfg/getniccfg

Synopsis
racadm setniccfg -d
racadm setniccfg -s [<ipAddress> <netmask> <gateway>]
racadm setniccfg -o
racadm getniccfg

Description for setniccfg
The setniccfg subcommand sets the controller IP address.
l The -d option enables DHCP for the Ethernet management port (default is DHCP enabled).
l The -s option enables static IP settings. The IP address, netmask, and gateway can be specified. Otherwise, the existing static settings are used.
NOTE: To use this command, you must have Log In DRAC 4 permission.

Subcommand

Definition
getractime
Displays the time from the controller.
NOTE: To use the setniccfg command, you must have Configure DRAC 4 permission.
NOTE: To use the getniccfg command, you must have Log In To DRAC 4 permission.

Subcommand

Definition
setniccfg
Sets the IP configuration for the controller.
getniccfg
Displays the current IP configuration for the controller.
NOTE: The terms NIC and Ethernet management port may be used interchangeably.